Apa itu REVERSE OSMOSIS ? Reverse Reverse osmosis (RO) is a separation process that uses pressure to force a solution through a membrane that retains the solute on one side and allows the pure solvent to pass to the other side. More formally, it is the process of forcing a solvent from a region of high solute concentration through a membrane to a region of low solute concentration by applying a pressure in excess of the osmotic pressure. This is the reverse of the normal osmosis process, which is the natural movement of solvent from an area of low solute concentration, through a membrane, to an area of high solute concentration when no external pressure is applied. The membrane here is semipermeable, meaning it allows the passage of solvent but not of solute. This phenomenon is commonly noticed in case of the water falling from the leaves of a tree.
The membranes used for reverse osmosis have a dense barrier layer in the polymer matrix where most separation occurs. In most cases the membrane is designed to allow only water to pass through this dense layer while preventing the passage of solutes (such as salt ions). This process requires that a high pressure be exerted on the high concentration side of the membrane, usually 2–17 bar (30–250 psi) for fresh and brackish water, and 40–70 bar (600–1000 psi) for seawater, which has around 24 bar (350 psi) natural osmotic pressure which must be overcome. This process is best known for its use in desalination (removing the salt from sea water to get fresh water), but it has also been used to purify fresh water for medical, industrial and domestic applications since the early 1970s.
Under –the-sink RO System Reverse Osmosis kapasitas kecil yang pemasangannya diletakkan di bawah sink atau lemari cabinet.
BENEFIT
• Performa Tinggi • Menghilangkan kotoran dari total spektrum • Ekonomis, Efisien, Aman & Praktis PARAMETER OPERASI TDS max. Iron max. Hardness max. Hydrogen Sulfide max. Mangan max. Turbidity max. Tekanan Masuk max. )
2.000 ppm 0.3 ppm 12 gpg = 205 ppm 0 ppm 0.05 ppm 1 ntu 30 – 100 psi ( min. /
Under –the-sink RO System
FITUR STANDAR
MODEL Home TRO 75 U Kapasitas produksi 75 galon per hari FITUR STANDAR Model
Kapasitas Produksi*
GPD TRO 75 u
*
75
Tekanan Operasi Maksimum
Dimensi inlet
Desain Recovery
100
3/8”
24 %
LPD
Berdasarrkan TDS air baku 1.000 ppm dan temperatur 25 Celcius
Motor ( 1 phase ) HP
Under –the-sink RO System
TYPE Commercial Kapasitas produksi 150 – 800 galon per hari
FITUR STANDAR
Model
Kapasitas Produksi*
GPD
Tekanan Operasi Maksimum
Dimensi inlet
Desain Recovery
Motor ( 1 phase ) HP
LPD
TRO 150 E
150
180
½”
24 %
1/2
TRO 250 E
250
180
½”
27 %
1/2
TRO 450 E
450
180
½”
27 &
3/4
TRO 800 E
800
180
½”
25 %
3/4
* Berdasarrkan TDS air baku 1.000 ppm dan temperatur 25 Celcius
Mobile Haemodialisys RO System
Mobile Haemodialisa Reverse Osmosis Kapasitas produksi 250 – 800 galon per hari MH RO adalah sistem reverse osmosis bergerak yang dirancang khusus untuk keperluan proses haemodialisa lokal, dengan demikian proses cuci darah dapat dilakukan di mana saja termasuk di rumah pasien. Seperti lazimnya sistem reverse osmosis MH RO dapat memurnikan air hingga 98 % dari kondisi air baku, ditambah dengan 30,000 mWs/cm2 UVC water sterilizer membuat MH RO ini mampu menghasilkan 99,99 % air murni dan sterile serta bebas pirogen sesuai dengan standar yang ditetapkan AAMI sehingga aman untuk pasien. Sedangkan kelebihan RO ini adalah dapat dipindah-pindah , instalasinya mudah, indah secara estetika & dilengkapi dengan smart relay untuk memonitor kesalahan.
FITUR STANDAR
KONDISI OPERASI • • • • • • •
Max. TDS Max. Iron Max. Hardness Max. H2S Max. Manganese Max. Turbidity Tekanan Masuk Min.
Model
1,000 ppm 0.1 ppm 17 ppm 0 ppm 0.05 ppm 1 ntu 30 psi
Kapasitas Produksi*
• • • • • • • • •
1 Micron & Carbon cartrige pre-treatment 30,000 mWs/cm2, UVC water sterilizer 4 titik monitor tekanan 2 titik sampling point TDS controler untuk produk1 False Alarm Smart Monitor 4 galons Pressure Tank up to 30 psi water pressure output2
Tekanan Operasi Maksimum
Dimensi inlet
Desain Recovery
Motor ( 1 phase ) - HP
GPD
LPD
MH 250
250
946
180
½”
27 %
1/2
MH 450
450
1.703
180
½”
27 &
3/4
MH 800
800
3.028
180
½”
25 %
3/4
•Berdasarrkan TDS air baku 1.000 ppm dan temperatur 25 Celcius • 1 Monitor dapat di tambah • 2 Untuk tekanan yang lebih besar dapat menggunakan tambahan pompa dan bak penampungan
Mobile RO System
Laboratorium Kapasitas produksi 250 – 800 galon per hari
FITUR STANDAR
Model
Kapasitas Produksi*
GPD
Tekanan Operasi Maksimum
Dimensi inlet
Desain Recovery
Motor ( 1 phase ) HP
LPD
ML 250
250
180
½”
27 %
1/2
ML 450
450
180
½”
27 &
3/4
ML 800
800
180
½”
25 %
3/4
* Berdasarrkan TDS air baku 1.000 ppm dan temperatur 25 Celcius
PT. Tirta Teknosys Jl. Panglima Polim raya no. 100 Jakarta 12130 Phone : + 62 21 726 6060 Fax : + 62 21 725 8358 Email :
[email protected] Website : www.tirtateknosys.com
